Product Description
The Bendix 5006086 ET-S2 Electronic Throttle Position Sensor Kit is a genuine replacement potentiometer kit designed for compatible commercial trucks equipped with Detroit Diesel electronic engine controls. This kit allows technicians to replace the throttle position sensor on an existing Bendix ET-S2 electronic accelerator pedal assembly without replacing the complete pedal unit.
The throttle position sensor plays an important role in electronic engine management by converting accelerator pedal movement into an electrical signal. This signal communicates the driver's requested engine speed to the electronic control module, allowing the engine to respond appropriately to changes in accelerator position.
The Bendix 5006086 features a three-pin electrical connector and includes the mounting screws necessary to secure the replacement potentiometer to the compatible electronic treadle assembly.
-
Genuine Bendix ET-S2 electronic throttle potentiometer kit
-
Manufacturer Part Number: 5006086
-
Designed for compatible Detroit Diesel electronic engine controls
-
Compatible with specified Bendix ET-S2 electronic treadle assemblies
-
Three-pin electrical connector
-
Includes replacement throttle position potentiometer
-
Includes two mounting cap screws
-
Converts accelerator pedal position into an electrical signal
-
Supports accurate electronic throttle control
-
Helps restore consistent accelerator response
-
Designed for commercial truck electronic throttle maintenance
-
Service replacement for a worn or malfunctioning potentiometer
-
Complete accelerator pedal assembly not included
-
New replacement kit
-
Sold individually
Bendix identifies the 5006086 as the Detroit Diesel potentiometer replacement kit for the ET-S2 electronic treadle. Older Bendix parts catalogs associate this kit with electronic treadle assembly 800607.
During installation, the replacement potentiometer must be correctly aligned with the electronic treadle's internal drive mechanism. Bendix specifies a mounting screw torque of 25 ± 5 inch-pounds for the Detroit Diesel potentiometer configuration.
Before ordering, verify the original electronic throttle assembly number, connector configuration, and engine control requirements. This kit is specifically designed for compatible Detroit Diesel ET-S2 configurations and should not be substituted for Cummins or Caterpillar potentiometer kits without verifying compatibility.
After installation, perform the operational tests described in Bendix service documentation to confirm proper idle-position voltage, full-throttle response, and smooth signal operation.
Important product distinction: Bendix 5006086 is a Detroit Diesel ET-S2 potentiometer replacement kit, not a complete throttle pedal assembly.
Bendix's official service documentation confirms the 5006086 part number, three-pin connector, and included mounting screws.
