Product Description
The Zerostart 3500048 Plate-Mount Immersion Engine Block Heater is designed to warm the engine coolant before startup using the specified plate mounting configuration. It is intended for Ford 6.6L and 7.8L diesel engines built August 1989 and later. Rated at 1,000 watts and 120 volts AC, it is designed for the specified electrical supply.
Unlike a conventional threaded plug heater, this design mounts at a designated access opening and positions its heating element in the engine water jacket. Heat is transferred into the coolant and surrounding engine structure while the equipment is parked, helping prepare the engine for cold-weather operation.
The later Ford design replaces the second core opening from the rear on the right side. Earlier engines require a different mounting configuration.
This replacement heater is suitable when the original element has failed or the correct mounting provision is available for an approved heater installation. Confirm whether the power cord, seals and other hardware are supplied with the stocked unit before ordering.
Specifications:
-
Part Number: 3500048
-
Brand: Zerostart
-
Manufacturer: Phillips & Temro Industries
-
Product Type: Plate-Mount Immersion Engine Block Heater
-
Compatible Engines / Equipment: Ford 6.6L and 7.8L diesel engines built August 1989 and later
-
Wattage: 1,000 W
-
Voltage: 120 V AC
-
Nominal Current (calculated): 8.33 A
-
Mounting Size / Configuration: Plate; 1.5-inch element opening
-
Compatible Replacement Cord: 3600008
-
Alternate Part Number Formatting: 350-0048
Verify engine identification, plate bolt pattern, gasket arrangement, clearance and supply voltage. Follow manufacturer installation procedures and ensure the element is surrounded by coolant before connecting power.