Product Description
The Zerostart 3500107 Immersion Engine Block Heater is designed to preheat coolant in compatible engines before starting in cold conditions. It is intended for Cummins ISX and QSX, 2007 and newer, select ISX12 and related configurations. Rated at 1,500 watts and 120 volts AC, it is designed for the specified electrical supply.
The immersion design places the heating element in the engine coolant through a designated mounting opening. Heat is transferred directly to the coolant and adjacent engine surfaces, helping reduce cold-soak effects and improve startup readiness in low ambient temperatures.
The ISX/QSX catalog installation is on the engine's right side. Compare the heater port rather than relying on displacement alone, especially on later X-Series configurations.
This replacement heater is suitable when the original element has failed or the correct mounting provision is available for an approved heater installation. Confirm whether the power cord, seals and other hardware are supplied with the stocked unit before ordering.
Specifications:
-
Part Number: 3500107
-
Brand: Zerostart
-
Manufacturer: Phillips & Temro Industries
-
Product Type: Immersion Engine Block Heater
-
Compatible Engines / Equipment: Cummins ISX and QSX, 2007 and newer, select ISX12 and related configurations
-
Wattage: 1,500 W
-
Voltage: 120 V AC
-
Nominal Current (calculated): 12.50 A
-
Mounting Size / Configuration: 26 mm (listed ISX/QSX configuration)
-
Compatible Replacement Cord: 3600008
-
Engine Generation: 2007 and newer ISX/QSX, select configurations
-
Alternate Part Number Formatting: 350-0107
Verify the engine identification, mounting opening, element clearance and supply voltage before ordering. Follow the manufacturer installation procedure, and do not apply power until the cooling system has been properly filled and the heater is immersed.