Product Description
The Zerostart 3500095 Threaded Immersion Engine Block Heater is designed to provide direct coolant preheating before cold-weather engine startup. It is intended for International MaxxForce 11 and 13; Detroit DD13, DD15 and DD16 (2008 and newer), select configurations. Rated at 1,500 watts and 120 volts AC, it is designed for the specified electrical supply.
The threaded body connects to the engine’s designated coolant opening, placing the electrical element in the coolant rather than heating the engine from the outside. Warming the coolant and surrounding metal before cranking helps reduce the effects of a cold soak and supports more dependable startup in winter conditions.
The Detroit listing places the heater in the right-side oil module below the intake. The MaxxForce installation uses a lower right-front location. Cord inclusion varies by configuration.
This replacement heater is suitable when the original element has failed or the correct mounting provision is available for an approved heater installation. Confirm whether the power cord, seals and other hardware are supplied with the stocked unit before ordering.
Specifications:
-
Part Number: 3500095
-
Brand: Zerostart
-
Manufacturer: Phillips & Temro Industries
-
Product Type: Threaded Immersion Engine Block Heater
-
Compatible Engines / Equipment: International MaxxForce 11 and 13; Detroit DD13, DD15 and DD16 (2008 and newer), select configurations
-
Wattage: 1,500 W
-
Voltage: 120 V AC
-
Nominal Current (calculated): 12.50 A
-
Mounting Size / Configuration: 27 mm thread
-
Compatible Replacement Cord: 3600008
-
Alternate Part Number Formatting: 350-0095
Verify the engine serial number, thread form and diameter, internal element clearance and electrical supply. Follow the manufacturer installation instructions; the element must be immersed in coolant before power is connected.