Product Description
The Zerostart 8601011 Threaded Immersion Engine Block Heater is designed to provide direct coolant preheating before cold-weather engine startup. It is intended for Caterpillar 3304 with oil cooler, 3306 and other compatible catalog-listed engines. Rated at 1,500 watts and 120 volts AC, it is designed for the specified electrical supply.
The threaded body connects to the engine’s designated coolant opening, placing the electrical element in the coolant rather than heating the engine from the outside. Warming the coolant and surrounding metal before cranking helps reduce the effects of a cold soak and supports more dependable startup in winter conditions.
The catalog gives a 5-1/4-inch element length; for the listed Caterpillar engines the threaded opening is toward the rear of the oil cooler on the left side.
This replacement heater is suitable when the original element has failed or the correct mounting provision is available for an approved heater installation. Confirm whether the power cord, seals and other hardware are supplied with the stocked unit before ordering.
Specifications:
-
Part Number: 8601011
-
Brand: Zerostart
-
Manufacturer: Phillips & Temro Industries
-
Product Type: Threaded Immersion Engine Block Heater
-
Compatible Engines / Equipment: Caterpillar 3304 with oil cooler, 3306 and other compatible catalog-listed engines
-
Wattage: 1,500 W
-
Voltage: 120 V AC
-
Nominal Current (calculated): 12.50 A
-
Mounting Size / Configuration: 3/4 inch NPT
-
Compatible Replacement Cord: 3600008
-
Element Length: 5-1/4 inches
-
Alternate Part Number Formatting: 860-1011
Verify the engine serial number, thread form and diameter, internal element clearance and electrical supply. Follow the manufacturer installation instructions; the element must be immersed in coolant before power is connected.